Agricultural Drone Cleaning

  Spreading System Maintenance   1. Flush the material tank with clean water, using a brush to remove any fertilizer residue.   2. Remove the reduction motor and take out the roller for cleaning with dish soap and a hard bristle brush.   3. Use a rust remover on the reduction motor drive shaft, disassembly shaft, transmission shaft, and bearings. After spraying, wipe them clean and apply grease to keep them lubricated and rust-free.       Spraying System Maintenance   1. Remove the pressure nozzles, nozzle filter, or the upper and lower centrifugal discs of the centrifugal nozzles, as well as the inlet and outlet filter of the pesticide tank. Soak them in water and use a brush and dish soap to clean off pesticide residues. 2. Fill the p...

TOPXGUN AGRI ACADEMY   In this tutorial, we will learn some tips on how to clean agri drones' Battery Anti-Spark Circuit to prevent ignition. The detailed procedures are as follows:     We wil wire up the plug of two centrifugal nozzles to prevent dust and water which might cause short-circuit, if there is no pair of plugs we can use tape to wrap the plug completely for protection. After the operation we have to check whether there is dust, fertilizer or rust on the anti-ignition module, we can use WD40 to clean. Then we use non-woven cloth to wipe it to ensure that each pole piece is cleaned in place to prevent rust.   Short-circuit ignition situation, even serious safety hazards may happen if the module is not cleaned up in time.